@kik@dice.camp
I've been trying PVA for supports for my minis on my #H2D. On the paper, it was perfect: water soluble filament, so that I can remove the support without damaging the print. Perfect. In reality:
- printing PLA on top of PVA often failed
- could not successfully print PVA < 0.2mm layer height… what's the point for minis? 
- that thing is literally glue, and it keeps clogging the nozzle.
Gladly, I found (on reddit) a great solution: PETG supports! Prints great, detaches easily.
I realize actually PETG detaches more easily than supports did on my resin printer, where I had to plunge the print in hot water for 5 minutes to make sure I could detach the support without damaging the fine details (arms, tails, swords, etc). I've been amazed how PETG works on those details without any hassle.
